Thank you friends very much for commenting, I am glad that you like this bow...
Blacksmith, I am just 70" ntn, it makes me problems drawing long draw
![traurig :(](./images/smilies/sad.gif)
. But at 30" draw I can pull a truck
![lachend :D](./images/smilies/cheesy.gif)
TomTom, this is low ring count ash, I think this one is no more than 4 or 5 years old. Often they have density of 0.8 SG even when are saplings.
Heiner, my friend, this is the begining, next one can be only better than bow before.
![zwinkernd ;)](./images/smilies/wink.gif)
This one came out little longer because hard character but all next will be clean and lighter in physical mass.
Agroman, I am preparing something special for you...you will see!
![lachend :D](./images/smilies/cheesy.gif)
Frankster, in the middle of the stave, on pic, is visible that it was full sapling, about 30 mm thick I think. Ash saplings are very strong if they are worked carefully.
This winter I had some private situation that made to delay a lot of bows that I promissed, some bad luck about everything and also about bowmaking, everything gone bad. Now, when I am in full working mode, I will keep my promises and make everything I said. I apology to all my friends that have been waiting too long, I will respond with some good bows for that. Now my working speed is 2-3 per week, again.
Best regards to all...!